Filter
Top Products
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
4
Servicing Notes
When servicing or replacing gas carrying
components disconnect from gas before
commencing operation and check appliance is
gas sound after completion. When checking for
gas leaks use a liquid leak detector at all joints
and connections to check for leaks in the system.
Use a product specifi cally manufactured for leak
detection. Leak testing of the appliance shall be
conducted in accordance to the manufacturer’s
instructions.
CAUTION: DO NOT USE A FLAME TO
CHECK FOR GAS LEAKS.
Do not use re-conditioned or unauthorised gas
controls.
Disconnect from electricity supply before
commencing servicing, particularly before
removing any of the following: control panel,
side panels, cooktop tray, or any of the electrical
components or cover boxes. Before electrical
reconnection make sure the range is electrically
safe.
1. To Remove the Hand Rail
Remove the handrail plastic blanking plugs and
remove the 2 end bracket fi xing screws.
2. To Remove Control Panel
Disconnect from electricity supply.
Pull off all the control knobs. Remove the handrail
(see 2) Remove the 2 cross headed screws that
were hidden by the handrail end brackets.
Open the broiler door and R H oven door and
remove the 2 screws underneath the control
panel.
Pull the control panel forward and support so that
the wires are not strained.
Reassemble in reverse order. When replacing
leads refer to the wiring diagram. Check operation
of timer, ignition, and oven light switches.
3. To Remove the Cooktop
Disconnect from electricity supply.
Remove the pan supports, cooktop burner caps
and tops. If there are screws holding the cooktop
burners to the cooktop, remove them (not the
spark electrode fi xing screws).
A Cooktop front fixing screws
B Cooktop rear fixing screws
Remove the 4 rear cooktop fi xing screws (B) and
the 4 front cooktop fi xing screws (A).
Remove the screws holding the fl ue grille stays.
Lift the cooktop clear of the appliance. Replace in
reverse order.
Reassemble in reverse order ensuring that the
leads are reconnected.
Check for correct burner operation.
4. To Remove a Side Panel
Disconnect from electricity supply.
Remove control panel (see 2). Pull the cooker
forward. Remove the 4 retaining screws for each
panel (2 at the front and 2 at the rear). The lower
front retaining screws (one each side) are situated
beneath the lower edge at the front corners of the
side panels
Reassemble in reverse order.