Filter
Top Products
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
8
15. To Change Main Oven Door Outer
Panel
Remove the two plastic blanking plugs from the
door handles. Remove the 4mm Hex headed
screws holding the handle to the door with the
hexagon key tool. Remove two screws from top
edge and two from bottom edge of the door.
Remove outer door panel. Fit door handle to new
panel. Fit the plastic blanking plugs to the fi xing
holes.
The handles should be above the fi xings.
Fit panel to door. If replacing the outer panel on
the right hand door (with the Thermodial) take
care to make sure the sensor of the Thermodial is
sealed to the door by the rubber grommet.
Reassemble in reverse order.
16. To Change Main Oven Door Catch
Remove outer door panel (see 15). Remove
screws ‘B’ holding catch assembly to inner door
panel. Fit new catch and reassemble in reverse
order.
Check correct door operation.
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that
hook is released. Proceed to the next hook and
release it in a similar way, and so on.
Fig. 4
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner
holes of the door, and proceed round the door
snapping in each hook in turn.
18. To Adjust Oven Door Catch Keep
Open oven door, slacken off locknut at base
of keep, and screw in or out as required until
required fi t is obtained. Retighten locking nut.