Filter
Top Products
12
SERVICING WARNING
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Servicing Notes
Disconnect from electricity supply before commencing servicing, particularly before removing any of the
following: control panel, side panels, ceramic hob, or any of the electrical components or cover boxes. Before
electrical reconnection check that the appliance is electrically safe.
1. To change oven light bulb.
Replacement bulb must be 15w 125-130v lamp, FOR OVENS, heat resistant to 300°C (570°F).
Turn off the power at the circuit breaker
Make sure the oven is cool. Open the oven door and remove the oven racks.
Unscrew the bulb cover by turning counter clockwise. It
may be very stiff .
Taking care to protect your fi ngers in case the bulb
should shatter, unscrew the old bulb.
Screw in the new bulb, screw back the bulb cover. Turn
on the circuit breaker and check that the bulb now
lights.
2 How to Move the Range for Servicing
Follow these procedures to remove appliance for servicing:
Turn off the power at the circuit breaker
The range is very heavy. Take great care. We recommend two people maneuver the range. Ensure that the fl oor covering is
fi rmly attached, or removed to prevent it being disturbed when moving the range around. You will need the leveling tool.
Remove the drawer
Pull the drawer out to its furthest
point.
Lift up the ends of the
plastic clips (one each
side) to release the
catches holding the
drawer to the side runners
and at the same time
pull the drawer forward
and away from the side
runners.
For safety’s sake push the drawer runners back out of the way. Put the drawer somewhere safe - do not refi t it until
you have fi nished, you will need access to the area behind the drawer.
Lower the front roller
Fit the leveling tool on the rectangular adjuster as shown.
Lower the front roller by turning the leveling tool clockwise
until the front feet are just clear of the fl oor.
Slide range forward to disengage the range from the anti-tip
bracket.
Disconnect electrical supply to appliance and unplug the
electrical supply cord.