Filter
Top Products
Rear spacer.
End cap
1) Remove and discard the nuts and bolts, which
hold the flue panel and extension panel together.
2) Remove the M5 Taptight screws from the rear
of the extension panel, position the splash back to
the upper rear edge of the extension panel, align the
fixing holes and secure with eight of the M5 screws.
3) Locate and fit the right hand end cap to the
assembly and secure with the four M4 nuts provided,
repeat this procedure to the left hand end.
4) Carefully locate and position the flue panel into
the assembly and secure with four M5 screws.
5) Position the completed assembly on the three
location brackets which are already fitted