Aga Ranges U104613-03 Range User Manual


 
 

 
     
Customer care
Please complete your details in the inside cover of
this Guide. Then replace this Installation Guide back
in the Customer Care Pack in the correct position.
Please inform the user how to operate the range
and hand over the Customer Care Pack.
Thank you.
Oven Light
Press the Main oven light switch and check that the
light is working.
Note. The oven light bulb is not included in the
guarantee
Check Ignition of Cooktop Burners
Operation of all cooktop burners should be
checked after the range and gas supply lines have
been carefully checked for leaks.
Check each burner in turn. There is a flame safety
device that stops the flow of gas to the burner if the
flame goes out. There is also a spark ignition system
that works when the knob is pressed in.
For each burner, push in and turn a knob to the (
) lighting position.
The igniter should spark and light the gas. Keep
holding the knob pressed in to let the gas through
to the burner for few seconds.
If, when you let go of the control knob, the burner
goes out, the safety device has not held in. Turn
the control to the off position and wait one minute,
then try again this time holding in the control knob
for slightly longer.
Quality of Flames
On Natural Gas the burners flames should be a
blueish color with, at most, a slight yellowish fringe.
On Propane gas the flames may be “softer”. The
cooktop burner flames may have a slight yellowish
tip.
If the flame burns with a long white tip you should
call for service.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF
POSITION.