Filter
Top Products
Selecting the Location for the Indoor and Outdoor Units:
The following should be reviewed prior to selecting the location for your instal-
lation.
Evaporator Unit (Indoor Unit)
Install the indoor unit level on a wall that can support the weight of the unit and
is not subject to vibration.
The inlet and outlet ports should not be blocked.
Install the unit near an electric outlet or special branch circuit.
Do not install the unit where it will be exposed to direct sunlight.
Install the unit where connection to the outdoor unit is easy.
Install the unit where the drain pipe can be easily installed.
Install in a location where the unit can be easily accessed for maintenance.
Ensure there is a clearance of at least 6 inches above and 5 inches on either
side of the unit.
Condensor Unit (Outdoor Unit)
If possible, do not install the unit where it will be exposed to direct sunlight. (If
necessary, install a blind that does not interfere with the air flow.)
Do not install the unit where a strong wind blows or where it is very dusty.
Do not install the unit where people can come into contact with the unit.
Install in an area where the noise from this unit will not disturb your neighbors.
Ensure there is a clearance of the following minimum distances from the unit:
Above: 24 inches
In front: 24 inches
Behind: 12 inches
Side with connections: 24 inches
Side without connections: 4 inches
INSTALLATION PRECAUTIONS
Notes on the remote control installation
• Keep the remote at least one yard from a TV or radio.
• Do not place in an area that is exposed to direct sunlight or a heat source
• Ensure batteries are inserted properly
6