Alto-Shaam 1000-TH/III Oven User Manual


 
O P E R A T I N G I N S T R U C T I O N S
U S E R S A F E T Y I N F O R M AT I O N
The Alto-Shaam cook and hold oven is intended
for use in commercial establishments by qualified
operating personnel where all operators are
familiar with the purpose, limitations, and
associated hazards of this appliance. Operating
instructions and warnings must be read and
understood by all operators and users.
S TA R T- U P O P E R AT I O N
BEFORE INITIAL USE:
Interior oven surfaces must be heated to remove
surface oils and the accompanying odor produced
during the first use of the oven.
1. Wipe all wire shelves, side racks and the full
oven interior with a clean, damp cloth. Install
the oven side racks, oven shelves, and external
drip tray. Shelves are installed with the
curved edge toward the back of the oven.
Insert the drip pan on the interior bottom
surface of the oven.
2. Close the oven doors.
Press and release control ON/OFF key.
Press the COOK key.
Press the up and down arrows to set the
cooking temperature to 300°F (149°C).
3. Press the TIME key.
Press the up and down arrows to set the
cooking time to approximately 2 hours.
Allow the oven to cycle for approximately
2 hours or until no odor is detected.
TH/III INSTALLATION/OPERATION/SERVICE MANUAL PG. 13
C A U T I O N
METAL PARTS OFTHIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
D A N G E R
AT NO TIME SHOULDTHE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND. DO NOT USE WATER JET
TO CLEAN.
SEVERE DAMAGE OR
ELECTRICAL HAZARD
COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.