Filter
Top Products
QUICKCHILLER • INSTALLATION/OPERATION/SERVICE MANUAL • 3.
IN STAL LATI ON
P
rior to moving the Quickchiller to the installation
site, check the dimensions of doors, passageways,
and ceiling heights in the areas through which the
cabinet must be moved. Also check the turning
radius if the cabinet must be moved around an
existing structure. The use of a fork lift or pallet
lift truck is required for moving and leveling most
Quickchiller models.
NOTE: In certain instances, it may be
necessary to remove doors and door
hardware to negotiate tight spaces.
SITE SELECTION
P
osition the Quickchiller to allow sufficient air
ventilation through the condensing unit(s). The
rear of unit should be no closer than 6" (152mm)
to any wall or structure.
Avoid installing the chiller immediately
adjacent to fryers, charbroilers, or any other
equipment producing grease laden air; heat
producing equipment such as ovens and
ranges; and steam discharging equipment
such as steamer ovens and kettles. Do not
locate the Quickchiller in direct sunlight.
Allow sufficient front clearance for
serviceability and for easy maneuvering of
food trolleys in and out of the cabinet.
®
S I T E I N S TA L L AT I O N
I N S T A L L A T I O N
CLEARANCE REQUIREMENTS
BACK: 6" (152mm) TOP: 6" (152mm)
SIDES: 4" (102mm) minimum at both sides.
18" (457mm)
MINIMUM CLEARANCE
FROM HEAT PRODUCING EQUIPMENT
.
5-YEAR LIMITED
WARRANTY ON
SELF-CONTAINED
COMPRESSOR
Effective from date of shipment.
(
EXCLUDES LABOR)
INSTALLATION REQUIREMENTS
Unit must NOT be tipped on its side
at any time.
Tipping will cause damage to the unit
and void the warranty.
One (1) Floor Drain: 1/2" (12,7mm) diameter
Unit must be installed level. Unit must not be
installed in any area where it may be affected by
steam, grease, dripping water, high temperatures,
or any other severely adverse conditions.
C A U T I O N
TO PREVENT PERSONAL INJURY,
USE CAUTION WHEN MOVING OR
LEVELING THIS APPLIANCE.