Filter
Top Products
Dairy Center
T
he
Dairy Center provide
s
convenient door storage for
spreadable items such as butter and
margarine. T
his compar
tment c
an be
moved to several different locations
to accommodate storage needs.
11
To Remove:
• Slide dairy center up and pull out.
To Install:
• Slide assembly in and down so that the hooks are
firmly seated on the door liner.
To Remove Dairy Door:
• Press in sides of dairy door and pull out.
To Install Dairy Door:
• Slide sides of dairy door inside dairy center until
hinge points snap into place.
Adjustable Deep Tilt-Out Door Buckets
(select models)
The Adjustable Deep Tilt-Out Door Bucket provides
easy access to food items stored in the door.
To Remov
e Bucket:
• Tilt bucket out.
• Pull straight out of the bracket.
To Install Bucket:
• Tilt the front of the bucket down slightly.
• Slide into bracket and tip upright.
To Mov
e Bucket Frame to Another Location:
• Remove bucket.
•
Lift bracket up and pull straight
out.
Place the bracket in a new loc
ation.
Door Buckets
Door Buckets c
an be moved to meet individual
storage needs.
T
o Remov
e:
• Lift bucket up and pull straight out.
To Install:
• Place bucket in desired door liner
retainer, push down until bucket stops.
Fresh Food Features
Door Storage
Beverage Chiller™/MiniChiller™
(select models)
The Beverage Chiller™ and
MiniChiller™ keep beverages and
other items colder than the rest of the
fresh food compartment. An air inlet
directs air from the freezer into the
chiller(s).
Controls
The chiller control is located on the left
side wall of the fresh food compartment.
Turn the control clockwise for colder
temperature.
To Remove Chiller(s):
• Unload the chiller(s).
• Slide the assembly up and pull straight out.
Note
• If the chiller is installed directly under the dairy
center or a door bucket, the bucket or dairy center
will need to be removed before removing the
chiller
.
Note
• The chillers will not operate properly if the air
intake hole is not aligned with the control location.
To Install Chiller(s)
• Align one of the air inlet holes with the hole cut-out
on the door.
•
Slide the assembly in and down so that the hooks
are firmly seated on the door liner.