Filter
Top Products
6
Installation
Full-Length Aluminum Handles
To Install:
1. Release top door trim by removing
Phillips screws from top of fresh food
door and retain screws for later use.
2. Align notches on back of handle with
retaining clips on doors. Insert
clips into notches and slide
handle down until it contacts
bottom trim.
3. Replace top door trim and Phillips
screws.
4. Repeat instructions 1-3 to install
other handle.
To avoid possible injury and damage to proper
ty
,
tape decorative panels (select models) securely into
place before removing door handles.
WARNING
To Remove:
1. Release top door trim by removing
Phillips screws from top of fresh food
door and ret
ain screws for later use.
2. Grasp handle firmly with both hands.
Slide handle upward approximately
3
⁄4" to release.
3. Repeat instructions 1-3 to
remove other handle.
T
o Reinstall:
1. Repeat in reverse order.
6. Align bottom of handle with lower
door tab. Press upper handle end to
door surface and firmly grasp lower
end of handle. Gently slide handle
upward until bottom of handle settles
on door surface, then reverse
direction, sliding downward to almost
engaging tab with clip.
7. Grasp the handle firmly and slide
down until it clicks. The audible click
indicates fastening clips are securely
interlocked.
2. Grasp the lower part of the handle
firmly and lift to remove.
To Remove:
1. Flex the handle away from the door
panel. Simult
aneously place door
handle removal card underneath
the base of the lower handle. Insert
the card to the line or until it stops.
Handle Extensions (select models)
To Install:
1.
Align and clip handle extension into position on the
handle. Press the extension over the door retainers.
To Remove:
1. Slide the extension down and unclip from door
ret
ainer
.
Door Clip