Filter
Top Products
5
Installation
Handle Installation
If not installed, the handle is located in the interior of
the fresh food section or attached to the back of your
refrigerator.
Remove and discard handle packaging and tape.
Handle design varies from refrigerator to refrigerator.
Please reference the appropriate instructions for your
model below.
Front Mount Handle
Materials Needed
• Gloves to protect hands
• Phillips screwdriver
• Plastic door removal card (or
1
⁄32" thick plastic card),
retain the card
To Install:
1. The handles are to be oriented
as shown.
2. Align front mount door handle
clip with the door tabs.
3. Ensure the handle clips are
positioned slightly above the
door tabs.
5. Push the handle down against the
upper door t
ab just enough to allow
it to hang unsuppor
ted.
4. Rotate the handle so that the
handle is flat against the door.
Handle
Clip
Door
T
ab
Materials Needed
•
1
⁄4" outer diameter flexible copper tubing
• Shut-off valve (requires a
1
⁄4" hole to be drilled into
water supply line before valve attachment)
• Adjustable wrench
•
1
⁄4" hex nut driver
Note
• Add 8' to tubing length needed to reach water
supply for creation of service loop.
1. Create service loop with copper
tubing (minimum 2' diameter).
Avoid kinks in the copper tubing
when bending the service loop.
2. Remove plastic cap from water valve
inlet por
t.
3. Place brass nut (A) and
sleeve (B) on copper
tube end as illustrated.
(Do not use old sleeve.)
4.
Place end of copper tubing into water
valve inlet por
t. Shape tubing slightly. Do
not kink – so that tubing feeds straight
into inlet port.
5. Slide brass nut over sleeve and screw nut
into inlet por
t. T
ighten nut with wrench.
IMPORTANT: Do not overtighten. Cross
threading may occur
.
6. Pull on tubing to confirm connection is
secure. Connect tubing to frame with
water tubing clamp (C) and turn on
water supply. Check for leaks and
correct if nece
ss
ary
. Continue to
observe the water supply connection
for two to three hours prior to moving
the refrigerator to its permanent
location.
7. Monitor water connection for 24 hours.
Correct leaks, if necessary.
A
B
C