Filter
Top Products
MIRACLE STEAMER
13
P/N 1010699 Rev. B
A.J. Antunes & Co.
11. Clean unit surface with a hot, clean, damp cloth
(not dripping wet) and wipe dry.
12. Re-install all parts and fasten the generator cover.
NOTE: To ensure proper steaming characteristics,
some mineral deposits must be present on generator
casting. If during cleaning, the casting does become
free of mineral deposits, add plain tap water to casting
and allow to boil off.
NOTE: In soft water areas, it may be necessary to add
a small amount of lime to generator to “season” it. This
will ensure proper steaming characteristics by produc-
ing a thin coating of mineral deposits on the casting.
Seasoning mixture consists of 2 ounces (59.15 milli-
liters) baking soda, 2 ounces (59.15 milliliters) lime
mixed with 2 ounces (59.15 milliliters) of warm tap
water.
Pour the seasoning mixture into the bowl portion of the
generator, turn the steamer rocker power (on/off) to
ON. Once the mixture has boiled off, remove the
remaining loose powder.
13. Plug in power cord and water line (if applicable).
Figure 8. Miracle Steamer Components
READY
ADD
ADD
WATER
WATER
Spatula (MS-150/250 only)
Liner (MS-150/250 only)
Drip Pan (MS-155/255/355 only)
Liner (MS-155/255/355 only)
Drawer (MS-155/255/355 only)
Top Cover
Wingnut
Cover
Diffuser
Steam Vent
MS-355 Shown
5. Examine all generator orifices (holes). If mineral
deposits have formed, place a flat blade screw-
driver into openings. Use a gentle twisting
motion to scrape openings clean.
NOTE: If the mineral deposits come off in “flakes” or in
layers, build-up is excessive.
6. Use a brass or stainless steel wire brush to
remove deposits from the generator surface.
7. Pour a delimer solution (not supplied) onto the
generator surface and allow to soak for one hour.
Be sure to follow the delimer manufacturer’s
directions for proper mixture and use.
NOTE: Use only a Aluminium safe de-liming product.
8. Remove the delimer solution from the generator
and rinse with clear water to remove traces of
delimer.
9. Clean the following parts in hot detergent water,
then rinse in clear water and allow to air dry:
• spatula/drawer • top cover
• liner • steam vent
• generator cover • diffuser
10. Clean steam chamber of any product spills.