Filter
Top Products
www.aristonappliance.us
LAVE-VAISSELLE ARISTON -
Notice d’installation
12
Instructions only for integrated custom panel
application models
On this models you can install a door panel out of wood or another material as you wish.
For its installation please confirm also to the installation sheet supplied.
Take the installation sheet and place it over the
panel as shown on pictures 20-21
Door panel installation.
Mark with the drill on the marked signs of the
installation sheet
Take the screws 0.16"diam. x 0.98"(diam.4x25 mm.)
supplied and insert them into the plastic hooks
(supplied).
20 21
Afterwards insert them into the holes of the panel
and screw them tight.
Stick the two velcro pads (supplied) on the
dishwasher front onto the areas as shown in photo
22. Do not peel remaining protection of the pads
immediately.
Insert the plastic hooks with the panel into the
appropriate slots on the dishwasher front. Then
push them upwards until it stops. Now peel the
protection off and press the panel firmly on the
dishwasher.
Open the door and insert the 0.15" diam. x 1.49"
(diam.4x38 mm.) screws (supplied) in the holes of
the frame and screw them tight to fix the panel.
22
+
+
4-22 lb ( 2-10 kg.
Adjusting of door tension
The door must be perfectly balanced. In the factory
the tension of the springs is regulated to ensure
that the door is perfectly balanced when light door
panels are mounted on the door. If heavier door
panels are used the door can be balanced by
simply turning the two screws (both screws must
be turned the same amount) located on the top
part of the machine. Use the C or C1 tool (see the
material needed table).
Please see also the installation sheet.
Installation