Filter
Top Products
Page 4
WARNING! Plumbing connections must comply with
applicable sanitary, safety and plumbing codes in your
area.
The machine can be connected to either a hot or cold
water supply. If a cold water supply is used, the washing
times will be longer but the performance will not be
affected.
The dishwasher comes with a 6-foot PEX water supply
line that has a 3/8" NPT female connection.
After determining where the water supply line will enter
under the sink, drill a 1-1/2" (38 mm ) access hole and
run the line to the approximate inlet valve location shown
in the figure below. The water line inlet valve is on the
right rear of the machine.
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily
accessible location, such as, beneath the sink.
It is important that the water supply line and the shut-off
valve have a sufficient flow volume. At last 3 gallons (12
liters) per minute must be able to pass through the
line. The water pressure should be 18-176 psi.
CORNER INSTCORNER INST
CORNER INSTCORNER INST
CORNER INST
ALLAALLA
ALLAALLA
ALLA
TIONTION
TIONTION
TION
2” clearance
If the dishwasher is installed in a corner, there must be
a minimum clearance of 2” (50 mm) from the side wall
so the door can open.
EE
EE
E
ASYASY
ASYASY
ASY
II
II
I
NSTNST
NSTNST
NST
ALLALL
ALLALL
ALL
CONNECTIONS CONNECTIONS
CONNECTIONS CONNECTIONS
CONNECTIONS
Drain hose boot
Ready to be cut to desired
drain connection. Only
one clamp required.
PEX tubing with 3/8”
compression fitting
PEX tubing has a 95-year
spec life. Fits American
dishwasher water supply
valves.
WW
WW
W
AA
AA
A
TER SUPPLTER SUPPL
TER SUPPLTER SUPPL
TER SUPPL
YY
YY
Y
(1) Water supply
(2) Water supply valve
(not supplied)
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water
line is connected to the dishwasher.
WARNING!
WARNING!
Do not use an extension cord for this appliance.
Electrical cord
110-120 volts, 15/20 amp
cord supplied with unit.
INSTINST
INSTINST
INST
ALLING ALLING
ALLING ALLING
ALLING
THE THE
THE THE
THE
TIP GUTIP GU
TIP GUTIP GU
TIP GU
ARDSARDS
ARDSARDS
ARDS
(OPTIONAL)(OPTIONAL)
(OPTIONAL)(OPTIONAL)
(OPTIONAL)
When it is not possible to fasten the dishwasher to the
cabinet, you should install tip guards to prevent the
machine from tipping when the door is opened. The tip
guards can be attached either to the floor or the wall.
The tip guards should be mounted behind the machine,
19” (483 mm) apart (measuring center to center) and
18-1/2” (470 mm) from the front of the machine. (Note:
This measurement could vary, depending on the
thickness of the custom panel, if any.)
Tip Guards
(P/N 8070851)
We recommend that you install tip
guards when it isn’t possible to fasten
the dishwasher to the cabinet.
Rear
Be sure to run the PEX tubing through the hole
to sink compartment before moving the
dishwasher into position.
NOTE: