Filter
Top Products
• After the unit mounting.
Clean the burners and reflector bowls with mild detergent and warm water. Wring excess water
• Line up the opening of the reflector bowls with the burners receptacle, hold the surface unit as
level as possible with th eptacle, then push the surface
units’ terminal into the receptacle.
receptacles as far a n the edge of
rse burners in water
has been removed, the reflector bowl can be lifted out of the
•
out of the sponge or cloth when cleaning them.
• Replace the burners and reflector bowls as follows:
e terminal just positioned into the rec
• When the shed into the
the surface unit opposite the receptacl
terminal is pu s it will go, push dow
e.
NOTE: Do not imme
liquids.
or an othey r
¾ LIFT-UP COOKTOP
You can access the area beneath of the cooktop fo
cleaning purposes by lifting up the cooktop. In orde
do so:
• Unplug the power cord from the wall
the front left and
of cooktop and pull it up.
• After lifting up the cooktop high eno
as shown.
ort rod.
soapy water. Use a
d areas.
• To lower the cooktop, lift the cooktop
e the suppo
previous position. Lower the cooktop i
During replacement of the cooktop, be
front edge of the cooktop covers the u
control panel.
NOTE: Do not drop the cooktop. Person
damage to the cooktop frame could result.
REMOVABLE STORAGE DRAWER
r
r to
• Hold the cooktop from right corners
ugh, set the
support rod into place
• Leave the cooktop on the tip of supp
• Wipe with warm
wool pad on heavily soile
soapy steel-
holding from
the front edge. Replac rt rod to its
n its place.
sure that the
pper edge of
al injury or
Support Rod
¾
or cleaning, you can remove the drawer by pulling it out until the stop
oint and lifting it up.
ever store any flammable material in the drawer.
¾ REPLACING THE OVEN LIGHT
F
p
N
Before any maintenance is started involving electrical parts of the appliance, it must be disconnected
from the power supply.
• Let the oven cavity and broil burner cool down.
• Switch off the electric supply.
• Remove the protective cover.
• Unscrew and replace the bulb with a new one suitable for using in high temperatures (300°C ~
570°C / 572ºF – 1058ºF) having the same specifications: 250V 60Hz, 15W, E14.
• Replace the protective cover.
NOTE: Oven bulb replacement is not covered by your guarantee.
23