Filter
Top Products
and connectors are properly fastened and
Turn temperature control knob to right
(clockwise)
Temperature setting too low
Oven takes 30-40 minutes to get up to
stabilized operating temperature.
CAUTION: THE FOLLOWING TESTS
ARE PERFORMED WITH LIVE POWER
WITH CONTROL BOX OPEN. THESE
TESTS TO BE PERFORMED ONLY BY
AN AUTHORIZED SERVICE AGENT.
1. Locate the two temperature contols
mounted on the hinged door, near the
cooling fan. Verify that ALL connections
Turn temperature knobs back and forth.
Do both lights go ON & OFF? If YES, then
temperature controls are OK. If NO, then
malfunctioning light indicates which control
needs further investigation. Use the
following steps to check.
Cooking too soon
THE PROBLEM THE CAUSE THE SOLUTION
tight. Power should be connected to
terminals labeled 240 & VAC COM.
2. Locate the two wires from each of the
temperature sensors (top left terminals
labeled PROBE). These have braided
insulation. Verify their integrity.
3. If necessary to test, disconnect one
sensor at a time, and use voltmeter to
measure resistance at sensor wires.
Compare to resistance chart in back of this
manual. If sensors show INFINITE
resistance, sensor is bad. Replace.