Filter
Top Products
Instructions for use
6
basin.
Defrost twice a year or when a frost layer of
around 7 (1/4") mm has formed. To start the
defrosting procedure, switch off the appliance
at the socket outlet and pull out the mains
plug.
All food should be wrapped in several layers
of newspaper and stored in a cool place (e.g.
fridge or larder).
Containers of warm water may be placed
carefully in the freezer to speed up the
defrosting.
Do not use pointed or sharp-edged
objects, such as knives or forks to
remove the frost.
Never use hairdryers, electrical heaters
or other such electrical appliances for
defrosting.
Sponge out the defrost water collected in the
bottom of the freezer compartment. After
defrosting, dry the interior thoroughly. Insert
the plug into the wall socket and switch on
the electricity supply.
Replacing the interior
light bulb
Should the light fail, switch off at the socket
outlet and pull out the mains plug. Then ensure
the bulb is screwed securely in the bulb holder.
Replace the plug and switch on. If the light
still fails, obtain a replacement E14 screw-
cap type 15 Watt (Max) bulb from your local
electrical store and then fit it (Fig. 4).Carefully
dispose of the burnt-out light bulb immediately.
Cleaning and care
1. We recommend that you switch off the
appliance at the socket outlet and pull out the
mains plug before cleaning.
2. Never use any sharp instruments or abrasive
substances, soap, household cleaner, detergent
or wax polish for cleaning.
3. Use luke warm water to clean the cabinet
of the appliance and wipe it dry.
4. Use a damp cloth wrung out in a solution
of one teaspoon of bicarbonate of soda to
one pint of water to clean the interior and
wipe it dry.
5. Make sure that no water enters the
temperature control box.
6. If the appliance is not going to be used
for a long period of time, switch it off, remove
all food, clean it and leave the door ajar.
7. We recommend that you polish the metal
parts of the product (i.e. door exterior, cabinet
sides) with a silicone wax (car polish) to
protect the high quality paint finish.
8. Any dust that gathers on the condenser,
which is located at the back of the appliance,
should be removed once a year with a vacuum
cleaner.
9. Check door seals regularly to ensure they
are clean and free from food particles.
10. Never:
• Clean the appliance with unsuitable material;
eg petroleum based products.
• Subject it to high temperatures in any way,
• Scour, rub etc., with abrasive material.
11. Removal of dairy cover and door tray :
• To remove the dairy cover, first lift the
cover up by about an inch and pull it off from
the side where there is an opening on the
cover.
• To remove a door tray, remove all the
contents and then simply push the door tray
upwards from the base.
12. Make sure that the special plastic container
at the back of the appliance which collects
defrost water is clean at all times. If you want
to remove the tray to clean it, follow the
instructions below:
• Switch off at the socket outlet and pull out
the mains plug
• Gently uncrimp the stud on the compressor,
using a pair of pliers, so that the tray can be
removed
GB