Instructions for use
4
in tightly closed containers. Never store products
that contain an inflammable propellant gas
(e.g. cream dispensers, spray cans, etc.) or
explosive substances. These are an explosion
hazard.
Temperature control
and adjustment
Operating temperatures are controlled by the
thermostat knob (Fig. 2) and may be set at
any position between 1 and 5 (the coldest
position).
The average temperature inside the fridge
should be around +5°C (+41°F).
Therefore adjust the thermostat to obtain the
desired temperature. Some sections of the
fridge may be cooler or warmer (such as salad
crisper and top part of the cabinet) which is
quite normal. We recommend that you check
the temperature periodically with a thermometer
to ensure that the cabinet is kept to this
temperature. Frequent door openings cause
internal temperatures to rise, so it is advisable
to close the door as soon as possible after use.
Before operating
Final Check
Before you start using the appliance check
that:
1. The feet have been adjusted for perfect
levelling.
2. The interior is dry and air can circulate
freely at the rear.
3. The interior is clean as recommended under
"Cleaning and care."
4. The plug has been inserted into the wall
socket and the electricity is switched on.
When the door is open the interior light will
come on.
And note that:
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
(noise), whether the compressor is running or
not. This is quite normal.
6. Slight undulation of the top of the cabinet
is quite normal due to the manufacturing
process used; it is not a defect.
7. We recommend setting the thermostat
knob midway and monitor the temperature
to ensure the appliance maintains desired
storage temperatures (See section Temperature
Control and Adjustment).
8. Do not load the appliance immediately it
is switched on. Wait until the correct storage
temperature has been reached. We
recommend checking the temperature with
an accurate thermometer (see; Temperature
Control and Adjustment).
GB