Filter
Top Products
Belshaw Bros., Inc. 1750 22
nd
Ave. S. Seattle, WA 98144 Phone 206-322-5474 Fax 206-322-
5. Make sure that the HEAT and PUMP
switches are in the OFF position. Connect
the EZ Melt to the power source.
To avoid damaging the heating element, make
sure it is completely covered with shortening
before you turn the heater on.
6. Turn the machine on using the HEAT
switch. When the heat is on, the heating
element melts shortening at 200 F/93 C.
The heat must also be on to operate the
pump.
7. Turn the pump on using the PUMP switch.
8. When you want to supply shortening to the
fryer, press the foot pedal.
WARNING
To avoid burning yourself, never touch the
nozzle while the machine is in use.
9. When the fryer has enough shortening in it,
release the foot pedal.
10. As needed, add shortening to the kettle, one
cube at a time. Always add a cube if the
shortening level drops to the tops of the legs
of the cube melter. (See Figure 2-4 & 2-4A.)
Figure 2-4. When to Add a Cube of
Shortening.
Figure 2-4A. (
EZ34 ONLY) When to Add a
Cube of Shortening.
To add a cube of shortening, follow these steps:
IF SHORTENING
LEVEL IS HERE
OR BELOW ADD
ONE CUBE OF
SHORTENING.
SIDE OF
CUBE
MELTER
BOTTOM OF
KETTLE
1. Position the filter assembly so you can
add shortening. The edge of the kettle
has one or two sets of holes in it. Use
the set of holes that is nearer to the
heater head. When two of the filter
frame’s pins rest in these holes, the filter
assembly hangs vertically. (See Figure
2-5.)
Figure 2-5. Positioning the Filter Frame for
Melting.
b. Place a solid cube of shortening on the
cube melter. Let one cube melt and be
pumped out before adding another cube.
Do not overload the EZ Melt.
BOTTOM OF
KETTLE
SIDE OF
CUBE
MELTER
IF
SHORTENING
LEVEL IS
HERE OR
BELOW ADD
ONE CUBE OF
SHORTENING
5425
6 MN-1316EN EZ Melt Model EZ18, EZ24, EZ34