Filter
Top Products
THE SHORTENING DOES NOT FLOW FREELY THROUGH THE FILTER
SYSTEM
Possible Causes What To Do
The hose is crimped. Straighten the hose.
WARNING
To avoid being burned, before doing any of the
following, turn off the EZ Melt and allow the
shortening to cool.
The hose is clogged with shortening. Soak the hose in warm water to help release the
clogged shortening. Hang it up and let it dry
before you use it again.
The drain tube is clogged with solid shortening. Remove the drain tube and soak it in warm water
to help release the clogged shortening.
The pickup tube is clogged with residue. Remove the pickup tube and clean it.
THE PUMP MOTOR WILL NOT RUN
Possible Causes What To Do
The connection of the power cord to the power
source is faulty.
Make sure the power cord is fully plugged in to a
proper power source.
The circuit breaker has been tripped. Press the reset button.
If the problem persists, consult your Belshaw
dealer, or call Belshaw.
Belshaw Bros., Inc. 1750 22
nd
Ave. S. Seattle, WA 98144 Phone 206-322-5474 Fax 206-322-
5425
EZ Melt Model EZ18, EZ24, EZ34 MN-1316EN 13