Filter
Top Products
Cleaning 3
Clean the EZ Melt after every use. Follow these
steps:
1. Turn on the heat and the pump.
2. Press the foot pedal to pump shortening out
of the EZ Melt and into a metal container or
fryer kettle.
3. When you cannot pump any more shortening
out of the EZ Melt, release the foot pedal.
Turn off the heat and the pump.
4. Disconnect the EZ Melt from the power
source.
5. Allow the shortening in the EZ Melt kettle
to cool to 115 F/46 C.
WARNING
Hot shortening can cause serious injury.
6. Clean the EZ Melt filter. Follow these steps:
a. Allow the filter assembly to cool to the
touch.
b. Lift off the filter assembly, holding it by
the frame.
c. Invert the filter assembly over a sink or
garbage can and shake the sediment off
of it.
d. Unsnap the filter to remove it from the
filter frame.
e. Rinse the remaining shortening and
crumbs off of the filter.
WARNING
Thoroughly clean and dry the floor if
shortening, water, or other materials are
spilled. Materials spilled on the floor may
cause serious injury and loss of life.
7. Remove the cube melter.
8. Loosen the two fasteners at the back of the
heater head, lift it off the kettle and place it
in a clean safe place. The foot valve and
cord will unsnap from the frame. See Figure
3-1.
Figure 3-1. Removing the Heater Head.
(Place heater head as shown above so no
damage is done to the element.)
Belshaw Bros., Inc. 1750 22
nd
Ave. S. Seattle, WA 98144 Phone 206-322-5474 Fax 206-322-
5425
10 MN-1316EN EZ Melt Model EZ18, EZ24, EZ34