Filter
Top Products
Model # 900149: Page 6
Initial Set Up
Do NOT plug in until steps 1-3 are completed.
1. Allow unit to sit upright for 4 hours.
2. Set probe length (see illustration 1):
x If using a 5 gallon round bottle, use the probe as it is supplied.
x If using a 5 gallon rectangular bottle, remove section C. Save for
future use.
x If using a 3 gallon bottle, remove sections C & B. Save for future
use.
3. Install bottle:
x Open door and place fresh bottle in front of tray.
x Clean fresh bottle with a soft cloth and warm soapy water then rinse.
x Remove entire plastic cap from top of bottle.
x Insert probe into bottle.
x Push down on probe until it is seated.
x Create a seal by turning handle clockwise until tight – do NOT over tighten.
x Slide bottle onto tray and close door completely.
NOTICE: When using a 5 gallon rectangular bottle, slide into place as shown in
illustration 2.