Filter
Top Products
Model # 900149: Page 8
Dispensing Hot Water
This unit dispenses water at temperatures that can cause severe burns. Avoid
direct contact with hot water. Keep children and pets away from unit while
dispensing. Never allow children to dispense hot water without proper and direct
supervision.
Note: After setup, hot water will be available in 15-20 minutes.
1. Position bottle, glass, pitcher or cooking pot securely below hot water tap.
x The left triangle below the hot water control indicates the location of the hot
water tap.
x The circular shapes in the drip plate help align the flow of water. This unit
dispenses water at a fast rate. To avoid splashes, hold cup as close to the tap
as possible.
2. Push hot water release button (red) inward and depress control downward to start
flow.
3. Release control once desired fill level is achieved.
Replacing an Empty Bottle
Notice: When your bottle is empty the dispenser will beep 3 times and the LED
nightlights will blink until a fresh bottle is connected.
You may also hear a sucking sound when the bottle empties. This is normal and is
another way to be alerted that your bottle is empty.
Replace empty bottle as soon as you notice it is empty.
There may be a small amount of water left in the bottle.
1. Open door and slide bottle out.
2. Remove probe from bottle:
x Turn handle counter-clockwise till loose.
x Pull probe straight up until completely out of bottle.
3. Install fresh bottle:
x Place fresh bottle in front of tray.
x Clean fresh bottle with a soft cloth and warm soapy water then rinse.
x Remove entire plastic cap from top of bottle.
x Insert probe into bottle.
x Push down on probe until it is seated.
x Create a seal by turning handle clockwise until tight – do NOT over tighten.
x Slide bottle onto tray and close door completely.