Filter
Top Products
Model # 900149: Page 9
PROPER CARE & CLEANING
General Cleaning
Perform: As needed
Time Required: 5 minutes.
Note: Do NOT use abrasive materials or chemical cleaners.
1. Clean cabinet surfaces with a soft cloth and warm soapy water.
2. Wipe dust from back of dispenser to improve efficiency.
3. Remove drip tray assembly by sliding it forward. Remove cover. Place tray and
cover in dishwasher or wipe parts clean with a soft cloth and warm soapy water.
Cleaning Water Tanks and Lines
Perform: Every 3 months or whenever an off-taste occurs.
Time Required: 30 minutes.
Requires: (1) empty 5 gallon bottle, (1) 2 gallon or larger bucket, clean cloths and
unscented household bleach.
Note: Best to do prior to loading a fresh bottle.
Step A: Remove Existing Water
1. Move dispenser away from wall and turn it 90q in either direction.
2. Turn energy saving switches to OFF.
3. Unplug power cord from wall outlet.
4. Remove water bottle and disconnect probe.
5. Place a 2 gallon or larger bucket under the drain plug
in the rear of the dispenser.
6. CAUTION: Remove drain cap and silicon plug. Cold
water will immediately flow into the bucket. Several
seconds’ later hot water will dispense.
Reminder - Place drain cap and silicon plug in a safe
location so they are not lost.
7. Once unit has drained, replace silicon plug and drain
cap.
8. Remove remaining water from reservoir by
dispensing from the cold and cool taps into a pitcher.
Step B: Sanitize Probe and Taps
1. In a clean bucket, make a sanitizing solution of one gallon tap water and 3
tablespoons of unscented household bleach.