Filter
Top Products
4
GETTINGSTARTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting washers, screws and spacers for mounting and set them
aside in a safe place where they will not roll away or get lost.
Important:Donotattempttooperateapplianceuntilitisproperlyinstalled.
CHOOSEALOCATION
When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing
location.
• DONOT mount over any heating or cooking appliance such as your range or
oven.
• DONOT mount over or near a sink.
• DONOTmount under, in front of or behind any under-cabinet light fixtures.
Note: If you are mounting multiple †SpaceMaker™ appliances, they should not
be mounted flush to one another. Allow at least 4” of space between appliances
for adequate cooling.
Note: If you are connecting this appliance to the receptacle of another
†SpaceMaker appliance such as the toaster oven or coffeemaker, make sure you
can easily unplug the appliance following use.
DETERMINECABINETTYPE
Prior to taping the mounting template and beginning to drill your holes, determine
if your cabinet has a flat bottom (B) or an overhanging lip (C). If your cabinet is
flat, follow STANDARD INSTALLATION; if the cabinet has a lip, refer to SPACER
MOUNTING INSTALLATION.
STANDARDINSTALLATION(FLATCABINET)
Important:Alwayswearprotectiveglassesorgogglestopreventinjurywhen
drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other
appliances or items. Open cabinets and remove contents to make mounting
easier.
3
Productmayvaryslightlyfromwhatisillustrated.
1. Mountedunit
† 2. Grindingbowl(Part#CG800-01)
† 3. Stainlesssteelgrindingblade
(Part#CG800-02)
† 4. ON/OFF(I/O)pulsecontrolbutton
† 5. Processingworkbowl
(Part#CG800-03)
† 6. Stainlesssteelchoppingblade
(Part#CG800-04)
† 7. Storagelid(Part#CG800-05)
8. Cordstorage(behindunit)
9. Cordmanagementhook(behindunit)
†Consumerreplaceable/removableparts
†1. MountingParts
(Part#SDC-MOUNTINGKIT)
16Spacers
4½"
4¼"
4
3
/16"
4
1
/16"
12Screws
41"
41½"
42¼"
4Washers
2. MountingTemplate(inbox)
A2
B
C
A1