Filter
Top Products
CLEANING AND MAINTENANCE
Caution: before any operation, disconnect electrically the oven.
GENERAL CLEANING
To keep the characteristics of brightness of the enamelled parts for a long time it is neces-
sary to clean the oven after each use. Once the oven is cold, you will be able to easily
remove the fat deposits by means of a sponge or a cloth damp with warm soapy water
and eventually a detergent to be found on the market. Never use abrasive cloths or spon-
ges, that could irreparably damage the enamel. On white ovens even the parts of the dash
board such as handgrip and knob have to be cleaned each time because they may beco-
me yellow due to the emissions of fat vapours. After the use, rinse throughly with water
the parts in stainless steel and dry them with a soft cloth or with a bockskin. In case of per-
sistent stain, use the normal non-abrasive cleaning agents or one of the specific products
for stainless steel or some warm vinegar. Clean the door glass only with warm water, avoi-
ding the use of rough cloths.
Cleaning the oven door
Unhooking the doors.
1. Set the oven's door wide open.
2. Lift the hinge jumpers by your thumb and index fingers, then turn them fully
outwards to the end of stroke (Fig.A).
3. Turn the door towards the closure position and lay it on the jumpers: in this
way the hinge's spring results as blocked. By fully closing the door the hin-
ges are unhooked from the connection slits which are integral with the oven's
muffle (sequence 1,2,3 of fig.B).
Hooking the doors
1. Insert the door by hooking the hinges to the connection slits set on the muffle
front.
2. Fully open the door when inserted, then push and turn the cross connections
which fasten the springs full scale in the oven direction.
3. Close the door and check its correct operation.
1
16