Bloomfield 0420 Coffeemaker User Manual


 
Fig. 5 Program Volumes
OPERATION (continued)
8
B. PROGRAM BREW VOLUMES
Each BREW VOLUME SELECT KEY is individually
programmable.
Keys may be programmed for pulse brewing to optimize
contact times and extraction rates, or to minimize overflowing
the brew chamber when using large amounts of grounds.
Up to 10 pulses may be programmed. Each pulse delay is
fixed at 15 seconds.
1. Place an empty airpot under the brew head. Install the brew
chamber (without filter) under the brew head
2. Press and hold BREW key until beep sounds and the indicator
lights flash.
3. Press and release the VOLUME SELECT KEY to be programmed.
Water will begin to flow into the airpot. When the desired water
level is reached, press the key again to stop the water flow.
For pulse brew:
a. Press the key to start the water flow.
b. Press the key again to stop the flow after the time desired for
the first pulse.
c. Press the key again to resume water flow.
d. Repeat until desired total delivered volume is reached.
NOTE: Water flow can be stopped and restarted up to 10 times per
brew. The delay between pulses is fixed at 15 seconds.
4. Press the BREW KEY to enter these settings into memory and
resume normal operation.
5. Run a normal brew with filter and grounds to verify settings.
Repeat steps 1 through 4 to program the other VOLUME SELECT KEY,
or to revise existing settings.