Filter
Top Products
10
TROUBLESHOOTING SUGGESTIONS
SUGGESTED REMEDY
Check power supply cord
Check / reset circuit breaker
Set for desired temperature
Allow to cool
Reset hi-limit (8786, 8788)
Examine wiring & connectors,
thermostat and heating element
Repair/replace as needed
Replace water bottle
Adjust amount of grounds
Adjust timer
Use one (1) genuine Bloomfield
filter per brew
Thoroughly clean brew chamber
Adjust coffee amount and grind
Check/reinstall gasket on
INSIDE of brew head
Plug into electrical power
Clean spray disk
Replace water bottle
Replace switch
Examine wiring & connectors,
brew switch and solenoid
Repair/replace as needed
Replace water bottle
Install new water bottle
Adjust water temp 195-205ºF
POSSIBLE CAUSE
Brewer unplugged or circuit
breaker tripped
Thermostat set too low
Hi-Limit thermostat tripped
Damaged internal component or
wiring
Water bottle empty
Too much coffee grounds
Timer out of adjustment
Too many filter papers or wrong
filter paper
Brew chamber dispense hole
plugged
Too much coffee or too fine a
grind
Spray gasket improperly
installed
Spray disk plugged
Brewer not plugged in
Water bottle empty
Bad BREW switch
Damaged internal component or
wiring
Water bottle empty
Damaged water bottle
Water not hot enough
SYMPTOM
Water won’t heat
Coffee level low
Coffee level too high or low
Brew chamber overflows
Sprays water from brew head
No brew
No flow from hot water faucet
Brewer overflows from basin
Poor coffee quality
Suggestions for consistently good coffee:
Keep brewer clean.
Use a quality coffee with a consistent roast.
Use proper grind and amount of coffee per brew.