Filter
Top Products
PROGRAMMING INSTRUCTIONS (continued)
13
PRECISE BREWING
TEMPERATURE™:
The brew cycle will not start
until the water in the tank is at
the proper temperature.
If START BREW key is pressed
and held for 3 seconds during
“Brew Wait” the brew will
proceed immediately.
Note: the following safety
features prevent multiple
unattended brews:
When the BREW LED is on or
flashing, repeated pressing of
the START BREW switch will be
ignored, (there will be a beep
each time it is pressed).
A Brew will only be activated or
put in Brew Wait when the
BREW LED is off.
Only one brew can be stored in
“Brew Wait” at a time.
FEATURES
1. Energizing the Brewer: Turn the brewer on by pressing the
POWER key. The brewer will start to fill the tank with the
message on the screen “filling…”. With the proper water
supply the tank should be filled in about 2½ minutes. Once
filled, the heating element will come on until the proper tank
temperature has been reached, (which will take about 20
minutes on 120-Volt models or about 12 minutes on 120/240
Volt models).
2. Brewing (Precise Temperature Brewing™ — PTB™): In
regular operating mode, the Satellite Brewer maintains the
tank temperature within +/- 1ºF of the brew temperature.
Normally this will mean that a brew will be started as soon as
the BREW switch is depressed. However, there may be a
slight delay if the BREW switch is depressed immediately
after a brew has been completed (notably on 120v models).
If the tank temperature is below the brew temperature, the
brew will be delayed going into the “Brew Wait” mode, with
the brew light flashing, and the message on the screen
“heating…”. As soon as the correct temperature is reached
the brew will commence with the BREW LED on continuously
during the brew. The time remaining in the brew will count
down on the display. During the brew if the BREW switch is
depressed, it will be ignored. Only if the brew is complete
can another brew be started.
To over-ride the Brew Wait Mode, press and hold the
START BREW key for 3 seconds when the brewer is in Brew
Wait mode (i.e. when BREW LED is flashing). The brew will
proceed immediately regardless of water temperature. This
feature should only be used when testing water volume,
otherwise the brew will proceed with the water below the
precise brew temperature.
3. Brew Cancel: To cancel a brew in progress, or to cancel a
brew waiting, depress the STOP BREW key: two beeps will
sound and the BREW LED will go out. Water flowing to the
brew basket will be stopped immediately, but, if there is
already water in the brew basket, it will take a few moments
before this drips through as coffee
4. Normal Operation (Non Brewing): When the unit is not
brewing, the Brewer maintains the water temperature at the
Precise Temperature for Brewing™ (PTB™). The heating
element will cycle on and off automatically to maintain this
temperature. The TANK HEAT LED will glow any time the
heating element is energized.