Filter
Top Products
Installation
English 16
7. Tighten all connections securely and replace terminal block cover.
8. Properly secure strain relief. See “Install Strain Relief” on page 12 for detailed
instructions.
Connect Gas Supply Shut off main gas supply valve before disconnecting the old range and leave it off
until the new hook-up has been completed. Don’t forget to relight the pilot on
other gas appliances when you turn the gas back on.
The range can be installed using rigid pipe or a CSA International-certified flexible
metal appliance connector. If using a flexible connector, always use a new
connector.
Apply pipe joint compound or Teflon
1
tape appropriate for use with LP gas and
Natural gas around all male pipe threads to prevent leaks.
The gas connection is located below the back panel of the range. See “Gas
Connection Location” on page 16. It is accessible through the drawer access
panel or from the back of the range. To reach access panel, remove drawer.
Important note for LP users The range is shipped from the factory for use with natural gas. For use with
propane (LP) gas, your range must first be converted using the LP conversion kit.
Figure 18: Completed Three Wire Range Cord Connection
Note:
DO NOT plug in range at this time.
green ground screw
1.Teflon is a registered trademark of DuPont
Figure 19: Gas Connection Location