Filter
Top Products
English 4
Before You Begin
Overview
Proceed to the sections that follow for step-by-step instructions.
Tools and Parts Needed • Range Power Supply Cord Kit (240V -30 Amp)
Note: Not necessary for Canadian installations; Canadian units are shipped
with the power cord already installed.
• Measuring Tape
• Phillips Head Screwdriver
• 1-1/4” (31.8 mm) Wrench
•Pencil
• T-20 Torx Screwdriver
• Screws (2) and Anchors (2) for Anti-Tip Bracket (Style will vary depending on
mounting surface)
•Level
• Drill and Drill Bit
• Soapy Water
• Pipe Wrench
• Teflon Tape
• Channel Lock Pliers
• Gas Leak Test Solution
• Gas Supply Line
• Gas Shut Off Valve
• Safety Gloves and Goggles
• Tape (Optional)
• Cloth or Cardboard (Optional - to Protect Floor)
Additional Parts Needed For
Hard Wire Installations
• Flexible Conduit
• Torque Wrench
• Note: Power Supply Cord Kit Not Necessary For Hard Wire Installations
Installation
Table 1: Overview
Step Task
1.
Preparation
2.
Apply Foam Tape
3.
Install Backwall Trim (Optional)
4.
Connect Electric
5.
Connect Gas Supply
6.
Test for Gas Leaks
7.
Test the Installation