Bosch Appliances L0609466 Range User Manual


 
Installation
Test the Installation
Turn on power at breaker
Test self-clean lock
Test Rangetop Burners:
Caution:
If the display flashes and beeps, the polarity of the wiring may be
reversed. Reversed polarity can damage the range and can result in
electrical shock hazard. Immediately switch off power at the breaker
and return to "Connect Electric" on page 11
Set oven to self-clean. Pull gently on oven door to verify that door is locked. Can-
cel self-clean mode.
Each burner must be tested for proper lighting, proper flame characteristics on the
low setting and proper flame characteristics on the high setting.
Test for proper ignition:
1. Push down and turn the knob to the flame symbol.
2. Verify that the ignitor/spark module clicks.
3. Once the air has been purged from the supply lines, verify that the burner
lights within four (4) seconds. After burner lights, turn knob to the off position.
4. Test each rangetop burner in this fashion. Call Service if any of the burners do
not light.
Test flame characteristics on the low setting:
1. Push in and turn the knob to the flame symbol until the burner ignites.
2. Turn knob quickly to the low setting.
3. Verify that the flame is:
A minimum height (approximately 1/4" or 6 mm).
Steady (The flame should not go out, lift or blow off of the burner. It
should carry over, or surround, the entire burner.)
The right color. It should be blue with an inner and outer cone. See Figure
24: Checking Flame Characteristics for more information.
4. Test each rangetop burner in this fashion. If any flame goes out, does not
carry over properly or is too large, contact service.
Test flame characteristics on the high setting:
1. Push in and turn the knob to the flame symbol until the burner ignites.
2. Turn knob to the high setting.
3. Verify that the flame is:
Steady (The flame should not go out, lift or blow off of the burner. It
should carry over, or surround, the entire burner.)
The right color. It should be blue with an inner and outer cone. See Figure
24: Checking Flame Characteristics for more information.
4. Test each rangetop burner in this fashion. If any flame burns yellow or does
not carry over properly, contact service.
English 22