Filter
Top Products
Safety
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Important Safety
Instructions
Appliance Handling Safety
Safety Codes and Standards
Electric Safety
WARNING: Do not repair or replace any part of the appliance unless specifi-
cally recommended in the manuals. Improper installation, service or mainte-
nance can cause injury or property damage. Refer to this manual for
guidance. All other servicing should be done by a qualified technician.
• Do not lift appliance by door handle. Remove the door for easier handling and
installation. See instructions in Use and Care Manual.
• Unit is heavy and requires at least two people or proper equipment to move.
• Hidden surfaces may have sharp edges. Use caution when reaching behind
or under appliance.
• This appliance complies with one or more of the following Standards:
• UL 858, The Standard for the Safety of Household Electric Ranges
• UL 923, The Standard for the Safety of Microwave Cooking Appliances
• UL 507, The Standard for the Safety of Electric Fans
• ANSI Z21.1-2000, The American National Standard for Household Cook-
ing Gas Appliances
• CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators
• CAN/CSA-C22.2 No. 61-M89 Household Cooking Ranges
It is the responsibility of the owner and the installer to determine if additional
requirements and/or standards apply to specific installations.
• Installation must conform with local codes or, in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.1.
• The appliance must be electrically grounded in accordance with local codes
or, in the absence of local codes, with the National Electrical Code ANSI/
NFPA 70, latest edition. (In Canada, installation must be in accordance with
the CAN 1-B149.1 and .2 Installation Codes for Gas Burning Appliances and/
or local codes)
• Before you plug in an electrical cord, be sure all controls are in the OFF posi-
tion.
• For appliances equipped with a cord and plug, do not cut or remove the
ground prong. It must be plugged into a matching grounding type receptacle
to avoid electrical shock. If there is any doubt as to whether the wall recepta-
cle is properly grounded, the customer should have it checked by a qualified
electrician.
• If required by the National Electrical Code (or Canadian Electrical Code), this
appliance must be installed on a separate branch circuit.
• Only a power-supply cord kit rated for this appliance and marked "for use with
ranges" shall be used.
• Installer - show the owner the location of the circuit breaker or fuse. Mark it for
easy reference.
• Important - Save these instructions for the local electrical inspector's use.
• Before installing, turn power OFF at the service panel. Lock service panel to
prevent power from being turned ON accidentally.
English 1