Filter
Top Products
stream, as shown in figure 8b. Operate the blender at
speeds 1 or 4 until mixture is thick and smooth
(approximately 10-20 seconds). Makes 1 ¼ cups.
The blender should be operated with careful considerĆ
ation as to what is required and/or desired. The speed
at which the blender is operated and the length of
operation for a given job will depend upon the degree
of fineness desired or the amount being blended.
When the blender is being used on dry materials, such
as nuts or bread, the best results will be obtained
when the blender jar is filled with approximately ½ cup
of material to be blended. If the blender does not start
(even after trying the highest speed), the blade has
become blocked by the contents.
The power unit should be:
Switched to off, O/Off" and unplugged.
The mixture should be removed and the contents
at the bottom of the jar loosened.
Before beginning to remove the contents from the
blender, make sure that the power unit has been
turned to off position O/Off." Remove the blender
from the power unit by turning the blender clockwise
while lifting. With the blender removed from the power
unit, the contents of the blender may now be poured
into aĂsuitable container or bowl, as desired. Replace
the cover on the highĆspeed drive.
All components of the blender, except the blade/base
assembly, are dishwasher safe. It is recommended
that the blade/base assembly be cleaned only under
flowing water rather than in the dishwasher. Soap and
detergent will tend toĂwash out the bearing lubricant of
the blade/base assembly. Do not use scouring cleanĆ
ers on any of the blender parts.
The power unit of the kitchen machine should be
cleaned with a clean, damp cloth only. Never use
coarse or caustic cleaning products to clean this apĆ
pliance. Never immerse the power unit in water. Never
use a steam cleaner.