Filter
Top Products
27
c. Place cover on housing and turn counterclockwise
until cover snaps into place and arrows are aligned,
see figure 11.
d. The continuous shredder is now assembled.
e. Place bowl on the power unit.
Depress the release button and raise arm so that
the bowl can be placed in position, and then lower
the arm to horizontal position.
f. Place continuous shredder on the midĆspeed drive
of the power unit with the arm in the horizontal
position and turn counterclockwise until it locks
into position.
Make sure the power unit is on a smooth, clean, suitĆ
able work surface and switched to the Off position,
O/Off." Pull out the electrical cord to the necessary
length and plug into a convenient outlet. The continuĆ
ous shredder is now ready for use.
Place items to be sliced, shredded or grated in feeding
funnel and be sure to useĂthe pusher to feed items into
the discsĂwhen in operation.
Learning how to feed food properly into the feed funnel
is the most important factor for proper slicing and gratĆ
ing:
1. For long slices or long shreds, place food into the
feeding funnel lengthwise.
2. For short or circular slices, place food in the feeding
tube on end. For example, if you wish to have cirĆ
cular slices of zucchini or carrots:
q cut to length not to extend above the top of the
feeding tube.
q place the cut zucchini or carrots in the feeding
tube on end until the feeding tube is packed.
3. To slice a single narrow item, a carrot for example:
q place the carrot in the feeding funnel opposite
the cutting edge ofĂthe disc.
Figure 11
Placing Slicer/Shredder
into Operation