Filter
Top Products
27
CARE AND CLEANING
26
CARE AND CLEANING
CLEANING THE FILTERS, FILTER HOLDER AND
BREWING HEAD
• The stainless steel Filters and Filter Holder
should be rinsed under water directly after
use to remove all coffee particles. Should the
fine holes in the filters become blocked, the
fine pin on the Cleaning Tool can be used to
clear the holes.
• The Brew Head interior should be wiped
with a damp cloth to remove any ground
coffee particles.
• Periodically run water through the machine
with the Filter Holder in place, but without
any ground coffee, to rinse out any residual
coffee particles.
CLEANING THE OUTER HOUSING /
CUP WARMING PLATE
• The outer housing and cup warming plate can
be cleaned with a soft, damp cloth (do not
use abrasive cleansers, pads or cloths which
can scratch the surface).
CLEANING THE DRIP TRAY
• The Drip Tray should be removed, emptied and
cleaned at regular intervals, particularly when
the Drip Tray Full Indicator is showing full.
• Remove the Drip Tray Full Indicator and Grid
from the Drip Tray, wash with warm soapy
water, using a non-abrasive washing liquid,
rinse and dry thoroughly.
• If further cleaning is required the full indicator
can be removed from the drip tray by
releasing the side snaps.
CLEANING THE STORAGE TRAY
• The Storage Tray can be removed after the
Drip Tray is removed then cleaned with a soft,
damp cloth (do not use abrasive cleansers,
pads or cloths which can scratch the surface).
DECALCIFYING
• After regular use, hard water can cause
mineral build up in and on many of the inner
functioning components, reducing the brewing
flow, power of the machine, and affecting the
quality of coffee.
• We advise decalcifying the machine on a
regular basis (every 2-3 months) using a
mixture of white vinegar and water. Follow the
instructions provided, or use the following as
a guide:
Diluted solution (for softer water)
• 1 part white vinegar
• 2 parts cold tap water
Concentrated solution (for harder water)
• 1 part white vinegar
• 1 part cold tap water
DECALCIFYING THE MACHINE
• Ensure the Selector Control is in the ‘Standby’
position, the Power On/Off button is set to
the ‘Off’ position and the machine is switched
off at the power outlet and unplugged.
• Remove the Filter Holder and Frothing
Attachment. Pour the mixture of white vinegar
and water into the water tank.
• Plug the machine into the power outlet and
switch on.
• Set Power On/Off button to the ‘On’ position
and the Selector Control to the ‘Standby’
position
• Place a large container under both the Brew
Head and the Steam Wand.
• When the brewing temperature is reached the
‘Heating’ light will switch off. Set the Selector
Control to the ‘Espresso’ position and let half
the mixture of white vinegar and water run
through the Brew Head.
• Set the Selector Control to the ‘Steam’
position and allow the remaining liquid to run
through the Steam Wand. When the liquid
stops flowing, set the Selector Control back to
the ‘Standby’ position.
• After decalcifying, remove the Water Tank and
rinse thoroughly then re-fill with fresh cold
water. To rinse the machine, run half the
water through the Brew Head and half
through the Steam Wand.
• The machine is ready for use.
NOTE: Do not clean any of the parts or
accessories in the dishwasher.
WARNING: DO NOT IMMERSE CORD, PLUG OR APPLIANCE IN WATER OR ANY OTHER LIQUID.
THE WATER TANK SHOULD NEVER BE REMOVED OR COMPLETELY EMPTIED
DURING DECALCIFYING.