Filter
Top Products
16
PAge heAder.....ASSEMBLY & OPERATION
MOTOR HEAD SAFETY CUT-OFF
The mixer is equipped with a motor head
safety cut-off. If the mixer head is lifted up at
any time while the mixer motor is switched
on, the safety cut-off will automatically
switch the motor off and set the mixer into
standby mode.
To restart the motor within 5 minutes, lower
the mixer head into the hotizontal (closed)
position, and turn the dial away then back to
the required speed setting. This will resume
mixing and the timer will resume counting.
To restart the motor after 5 minutes or more,
lower the mixer head and turn the dial to
OFF then back to the required speed. The
timer will start from 0.
To turn the mixer off (instead of restarting),
turn the dial to OFF, and unplug from
the wall.
ELECTRONIC PROTECTION
CUT-OFF - CURRENT OVERLOAD
The mixer is equipped with an electric
protection cut-off and will automatically
stop operating if the motor is stalled or
overloaded. This is normally a result of
excessive ingredients being processed at
one time. Should the mixer go into this
mode, the LED indicator band will flash and
the error message “E1” will flash on the LCD
screen and the buzzer will beep 3 times.
If this error occurs, turn the speed control
dial to the OFF position, switch the
appliance off at the power outlet and unplug
the cord. Remove some of the ingredients in
the mixing bowl and then restart the mixer.
THERMO CUT-OFF -
TEMPERATURE OVERLOAD
The mixer is equipped with a self-resetting
safety device which safeguards against
overheating the motor with excessive
loads. If overheating occurs, the mixer will
automatically activate the overheating
protection device and the motor will switch
itself off. Should the mixer go into this
mode, the LED indicator band will flash and
the error message “E2” will flash on the LCD
screen and the buzzer will beep 3 times.
If this error occurs, turn the speed control
dial to the OFF position, switch the
appliance off at the power outlet and unplug
the cord. Wait at least 15 minutes before
restarting the mixer.