Filter
Top Products
Breville recommends safety first
We at Breville are very safety conscious. We design and manufacture consumer products with the safety of you,
our valued customer foremost in mind. In addition we ask that you exercise a degree of care when using any
electrical appliance and adhere to the following precautions:
Important safeguards for your Breville Ikon Grill
• Carefully read all instructions before operating and
save for future reference.
• Remove any promotional stickers or labels before
using the Ikon Grill for the first time.
• Do not place the Ikon Grill near the edge of a bench
or table during operation. Ensure the surface is
level, clean and free of water, etc.
• Do not place the Ikon Grill on or near a hot gas or
electric burner, or where it could touch a heated
oven. Use the Ikon Grill well away from walls.
• Provide adequate space above and on all sides for
air circulation around the Ikon Grill.
• Do not place the Ikon Grill on any surface that may
be affected by heat. The use of a heat resistant
mat is recommended on these surfaces.
• Always ensure the Ikon Grill is properly assembled
before use.
• Do not touch hot surfaces. Use the handles to lift
and open the top plate. Take care when using the
Adjustable Grilling Height Control.
• Allow the grill to cool down before releasing the
removable plates. Do not release the removable
plates while the grill is being operated.
• Always switch off the grill at the power outlet
before releasing the removable plates.
• Do not leave the Ikon grill unattended when in use.
• Do not place anything on top of the Ikon Grill when
the lid is closed, when in use and when stored.
• Always switch the Ikon Grill off at the power outlet,
then unplug and allow to cool, if appliance is not in
use, before cleaning, before attempting to move the
appliance, disassembling, assembling and when
storing the appliance.
• Keep the exterior housing and the non-stick
cooking plates clean. Follow the cleaning
instructions provided in this book.
• The appliance is not intended to be operated
by means of an external timer or separate
remote-control system.
4