Breville BJE510XL/A Juicer User Manual


 
18
PAge heAder.....
CARE & CLEANING
Ensure the juicer is turned off by pressing
the ON/OFF button on the control panel to
OFF. Then unplug the cord.
Ensure the juicer is correctly disassembled.
Refer to Disassembling your juicer.
NOTE
FOR EASIER CLEANING:
Clean as you go and avoid dried on
juice or pulp residue.
Immediately after each use, rinse
removable parts in hot water to remove
wet pulp. Allow parts to air dry.
To minimize cleaning, line the pulp
container with a produce bag to
collect the pulp. Pulp can then be used
in other dishes or as compost for the
garden or discarded.
CLEANING THE MOTOR BASE
1. Wipe the motor base with a soft, damp
cloth then dry thoroughly.
2. Wipe any excess food particles from the
power cord.
NOTE
Do not use abrasive scouring pads
or cleaners when cleaning the parts
or motor base as they may scratch
the surface.
CLEANING THE FILTER BOWL
SURROUND, JUICER COVER, FOOD
PUSHER, PULP CONTAINER
1. Wash all parts in warm soapy water with
a soft cloth. Rinse and dry thoroughly.
NOTE
The filter bowl surround, juicer cover
and pulp container are dishwasher
safe. (top shelf only)
CLEANING THE NUTRI DISC™
For consistent juicing results always ensure
that the Nutri Disc™ is thoroughly cleaned
using the supplied cleaning brush.
1. Soak the Nutri Disc™ in hot soapy
water for approximately 10 minutes
immediately after juicing is completed.
If pulp is left to dry on the filter it may
clog the fine pores of the filter mesh
thereby lessening the effectiveness of
the juicer.
2. Using the cleaning brush, hold the juice
disc under running water and brush
from the inside of the basket to the outer
rim. Avoid touching the small sharp
blades in the center of the Nutri Disc™.
After cleaning the Nutri Disc™, hold
it up towards a light to ensure the fine
mesh holes are not blocked. If the holes
are blocked, soak the Nutri Disc™ in hot
water with 10% lemon juice to loosen the
blocked holes. Alternatively, wash the
Nutri Disc™ in the dishwasher.