Filter
Top Products
9
Replace the Charcoal Filter every 2 months, or
60 tank refills, more if you have hard water.
To order replacement Charcoal Filters, call
Breville Customer Service on 1-866-BREVILLE or
visit www.breville.com.
We recommend removing the Water Filter if you
choose not to replace the Charcoal Filter every
2 months, as the filter may clog and affect the
smell and taste of the water.
Note
One-time priming process
Priming fills the internal tank with water and cleanses
the brewing system. You cannot use your Brewer until
it has been primed for its first use.
If the Brewer has been exposed to temperatures
below freezing, allow the Brewer at least two
hours to reach room temperature before priming.
A frozen or extremely cold Brewer will not prime
properly and can cause damage.
Note
1. Unwrap the power cord and plug the Brewer
into a grounded outlet.
2. Place a 12 oz. mug on the Drip Tray Plate. The
drip tray plate and drip tray can be removed to
accomodate taller mugs and travel mugs.
3. Fill the Water Tank with water until it is
approximately 1 inch below the top edge.
The Water Tank can be filled in two ways:
a) Remove the Water Tank Lid and pour
water directly into the Water Tank while it
is still attached to the Brewer, then replace
the Lid.
b) Remove the Water Tank Lid, then gripping
the handle located on the left side of the
Water Tank, lift upwards. Fill with water.
Place the Water Tank back onto the Brewer
and replace the Lid.
4. Press and release the Power Switch located on
the lower back, right side of the Brewer.The
Power Switch is spring loaded and will return to
its original position.
5. The Water Tank LED will illuminate. The LCD
screen will illuminate and indicate ‘PRIME’. The
‘BREW’ button will illuminate and flash.
If the Water Tank is empty or not in place on the
Brewer, the Water Tank LED’s will flash and the
LCD screen will indicate ‘REFILL TANK’. None of
the control panel buttons will be active until
water is added to the Water Tank.
Note
6. A K-Cup
®
should not be used for the one-time
priming process.
7. Press the ‘BREW’ button.
8. The Brewer will automatically fill with water and
make a vibrating sound. This is normal. The
Brewer will then cease to vibrate and begin
heating the water. This entire process will take
approximately 4 minutes. The LCD screen will
indicate 'HEATING' during this period.
The Brewer will take about 4 minutes to heat up
during the priming process.
Note
wer
™
and
der and
ap the
c.
hen rinse
ey residue
the
Filter
der so it
der
when the
he Water
from
e
to place.
BR9013 BKC600XL_IB_AMEND.qxp 11/10/07 21:43 Page 9