Filter
Top Products
The My
ground
a) Use a
K-Cu
b) Use t
K-Cu
After bre
the K-Cu
Brewing
To replac
Locking
Insert K-
aligning
with the
Use caut
needle o
Head tha
Stopping
To stop bre
and releas
Brewer to
hot cocoa
and the LE
longer be
‘ON-OFF T
panel butto
back on.
You may
your nex
recomm
Brewing
then dis
the brew
Operating your Breville Gourmet Single Cup Brewer
™
continued
a. The LCD screen will indicate the default brew
size (7.25 oz.). To choose a different size, press
the to go up in size or the button to go
down in size.
Select from a stronger small cup (5.25 oz. serving),
a small mug (7.25 oz. serving), a large mug (9.25
oz. serving) or a travel mug (11.25 oz. serving).
The small mug (7.25 oz. serving) is the default
brew size. To program your favorite brew size,
refer to Setting the ‘BREW SIZE’ feature (page 20).
Note
b. Once the brew size is selected, press the ‘BREW’
Button. The ‘BREW’ button will stop flashing, the
and buttons will no longer be lit. The
LCD screen will indicate ‘BREWING’ and the
selected brew size.
If the ‘BREW’ button is not pressed in 60
seconds, the LCD screen will indicate ‘OPEN
HEAD’ and the ‘BREW’ button will be disabled to
prevent accidental activation. To re-activate the
brew sequence, open the Brewing Chamber
Head by raising and lowering the Safety Locking
Arm completely.
Note
12. The LCD screen will indicate ‘BREWING’, however
there may be a short pause before the brewing
process begins. The process lasts about 60
seconds and ends with a burst of air to remove
all liquid from the My K-Cup
®
Holder.
There is extremely hot water in the My K-Cup
®
Holder during the brewing process. To avoid risk
of injury, do not raise the Safety Locking Arm or
open the Brewing Chamber during the brewing
process.
Following the brew, the LCD screen will indicate
‘HEATING’ as the Brewer heats the water for the
next brew cycle. This process lasts about 15
seconds. The pump will make a vibrating sound.
This is normal.
Note
13. Raise the Safety Locking Arm, remove the
assembled My K-Cup
®
Holder. Use caution as
the My K-Cup
®
Holder will be hot.
14. Disassemble the My K-Cup
®
Holder by removing
the Lid from the Holder in a counter-clockwise
direction. Remove the Filter Basket from the
Holder, discard the grounds and rinse out the
Filter Basket and Holder.
15. Enjoy your first cup of gourmet coffee, tea or
hot cocoa!
14
BR9013 BKC600XL_IB_AMEND.qxp 11/10/07 21:43 Page 14