Breville BKC600XL/BKC700XL Coffeemaker User Manual


 
30 31
CARE & CLEANING CARE & CLEANING
STORAGE
Before cleaning or moving the Brewer to
a different location, ensure the Brewer
has been turned off. Switch off at the wall
outlet, unplug the power cord and allow the
machine to cool. The Water Tank should be
emptied and dried thoroughly.
• Store your Brewer in its upright position
to avoid water leakage from the inner
tank.
• Store your Brewer in a frost free
environment. Storing the Brewer in a
cold environment runs the risk of water
freezing inside the Brewer and causing
damage. If your Brewer has been stored
in an environment below freezing, ensure
to let it warm to room temperature for at
least 2 hours before using.
• When preparing to use the Brewer after
storage, we recommend rinsing the
Water Tank with fresh water and running
three cleansing brews without a K-Cup
®
(refer to Brewing Hot Water, page 18).
BKC600XL PRIMING
INSTRUCTIONS
1. Follow the instructions, Installing the
Water Filter (page 9) and the One-time
Priming Process (page 10). The Brewer
should be turned on and the Water
Tank should be filled and illuminated.
2. The LCD screen will indicate ‘READY
TO BREW’. The and buttons
will illuminate and the ‘BREW’ button
will illuminate and flash for up to
60 seconds.
NOTE:
If the ‘BREW’ button is not pressed
in 60 seconds, the LCD screen
will indicate ‘OPEN HEAD’ and the
‘BREW’ button will be disabled to
prevent accidental activation. To
re-activate the brew sequence,
open the Brewing Chamber Head
by raising and lowering the Safety
Locking Arm completely.
3. Place a cup or mug on the Drip Tray
Plate. The drip tray plate and drip tray
can be removed to accomodate taller
mugs and travel mugs.
4. Raise the Safety Locking Arm. The
Brewing Chamber will open toward you.
5. The Water Tank LED will illuminate. The
LCD screen will illuminate and indicate
'PRIME'. The 'BREW' button will
illuminate and flash.
6. A K-Cup
®
should not be used for the
one time priming process.
7. Press the 'BREW' button. The Brewer
will fill with water and make a vibratin
sound. This is normal. The Brewer will
then cease to vibrate and begin heating
the water. The LCD screen will indicate
'HEATING' during this period.
8. Once the water is heated, the LCD
screen will no longer indicate
'HEATING'. The 'BREW' button
will illuminate and flash for up to 60
seconds.
9. Press the 'BREW' button. This will start
a cleansing brew which will complete
the priming sequence. The LCD screen
will no longer indicate 'PRIMING'. Hot
water will flow into your mug. When the
flow stops, discard the hot water.
10. The LCD screen will indicate ‘HEATING’
as the Brewer heats the water for the
next brew cycle. Once the water is
heated, the LCD screen may indicate
‘REFILL TANK’.
11. Fill the Water Tank with water up to the
'MAX' mark on the viewing window.
12. The LCD screen will indicate ‘OPEN
HEAD’. Open the Brewing Chamber
Head by raising and lowering the Safety
Locking Arm completely. The LCD
screen will indicate ‘READY TO BREW’.
13. The one-time priming process is now
complete and you are ready for your
first K-Cup
®
brew (page 12) or My
K-Cup
®
brew (page 14).