Filter
Top Products
1. BEFORE STARTING
1
.1 INSPECT THE CONTENTS OF THE BOXES
• Inspect the exterior of the unit for shipping damage. Ensure that there is
no damage to the door, door latches, main switch, etc.
• Inspect the interior of the unit for damage. Ensure that blower assembly, heat
recovery core (HEPA 3000 et HF 3.0), energy recovery core (HEPA 4000),
insulation, dampers (HEPA 2000, HF 2.0, HEPA 3000, HF 3.0 and HEPA 4000),
prefilter, HEPA filter, etc. are all intact.
- 6 -
2. TYPICAL INSTALLATIONS
Installations may vary according to the model number and the position in which
the unit is installed. Use the following illustrations as guidelines to help you decide
on how your unit will be installed.
All the units should be hung to the joist, and installed either vertically or
horizontally. NOTE: For more details, see Point 5.3 in Section 5 INSTALL THE
UNIT.
In every case, bathroom fans and a range hood should be used to exhaust stale
air. Also, for homes with more than one level, we recommend one exhaust
register at the highest level.
There are 3 installation methods: Stand Alone, Central Draw Point and Return-to-
Return Installation.
NOTE: An electrical outlet has to be available within 3 feet from the unit.
CAUTION
Remove the cardboard strip inside the unit (if applicable).
WARNING
To avoid risk of suffocation, discard the plastic bag wrapping the unit.
0
!