Filter
Top Products
9
POWDER PRODUCT STRENGH ADJUSTMENT
The strength of the individual powdered beverages can be adjusted by changing the hopper motor speed. See
menus under “DRINK STRENGTH #” in the program menus to adjust the hopper dispense rate for each hop-
per.
DRAINING THE HOT WATER TANK
CAUTION - The dispenser must be disconnected from the power source throughout these steps
1. Disconnect the dispenser from the power source.
2. Open front door and place ON/OFF/NIGHT switch in the “OFF” (center) position and let the water in the tank
cool before draining.
3. Shut off and disconnect the incoming water supply.
4. Remove the drip tray and access panels below the door.
5. Pull the clamped end of the silicone tube out of the dispenser and direct it into a drain or a container large
enough to hold the volume of water in the tank, 7.2 gallons.
6. Make certain the shut off clamp is locked tightly on the tube, and then remove the snap type clamp and plug
from end of tube.
7. Carefully release the shut off clamp to let the water drain from the tank.
NOTE - The dispenser must be refilled using the INITIAL FILL & HEAT steps before reconnecting to the power
source.
PREVENTIVE MAINTENANCE
Bunn-O-Matic
®
Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance
should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic
®
Corporation at
1-800-286-6070.
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.
Touchscreen special cleaning instructions:
• Use a soft lint-free cloth. The 3M Microber Lens Cleaning Cloth is especially recommended for cleaning
touch panels without requiring liquid cleaner.
• The cloth may be used dry, or lightly dampened with a mild cleaner or Ethanol.
• Be sure the cloth is only lightly dampened, not wet. Never apply cleaner directly to touch panel surface; if
cleaner is spilled onto touch panel, soak it up immediately with absorbent cloth.
• Cleaner must be neither acid nor alkali (neutral pH).
• Wipe the surface gently; if there is a directional surface texture, wipe in the same direction as the texture.
• Never use acidic or alkaline cleaners, or organic chemicals such as: paint thinner, acetone, tolulene, xy-
lene, propyl or isopropyl alcohol, or kerosene.
• Suitable cleaning products are commercially available pre-packaged for use; one example of such a prod-
uct is Klear Screen™ <http://www.nushield.com/products_main_klear.htm>, or commercially available off-
the shelf retail brands such as Glass Plus® Glass and Surface Cleaner made by Reckitt-Benckiser <http://
www.glassplus.com/>.
• Use of incorrect cleaners can result in optical impairment of touch panel and/or damage to functionality.
NOTE: Most products contain 1-3% Isopropyl Alcohol by volume, which is within acceptable limits for Resis-
tive Touch Panel cleaning use.
CAUTION: Many products contain Ammonia, Phosphates, and/or Ethylene Glycol, which are NOT ACCEPT-
ABLE; check product content label carefully.
45304.1 090611