Filter
Top Products
11
Ads
• The BrewWISE
®
Recipe Writer can be used to transfer ad messages from the BrewWISE
®
software into the brewer by using an ad
(advertisement) card. Each position can hold five 16-character lines, so that the total ad stored in the brewer can consist of ten
16-character lines. Ads are displayed in screens, each 2-line screen displaying for a few seconds in rotation while the brewer is
idle. Writing is done in the same manner as with recipes, except that two write cycles are required. The ad (advertisement) card
contains two memory chips labeled #1 and #2. Before writing, the card must be positioned on the box as shown with the #1 chip
above the indicated alignment target. After successfully writing to #1, the application will prompt the user to reposition the card
so that chip #2 is aligned with the target. If ads already exist in a brewer, writing only the first ad position may provide
unexpected results. For best results, always write both positions when updating existing ads on a brewer, even if the second
position consists only of blank lines. For a more complete explanation of writing to cards, see the previous section entitled
“Writing Recipes”. Note: Although blank lines may be left at the end of an ad, leaving one complete ad screen blank can
cause undesired results. The application will warn the user if unacceptable combinations are encountered.
• Completely erasing ads can be accomplished by writing two positions consisting entirely of blank lines.
34446 070804