Bunn GR10 Series Coffeemaker User Manual


 
7
New Recipe
Clicking “New Recipe” from the Switchboard screen brings up the main Recipe form. After a Coffee Name has been typed in and
the “Enter” or “Tab” key is pressed, the remaining three buttons on the form will become active. Recipe volume parameters may
be entered or saved in either English or Metric units. Depending on the specific software in your brewer, Recipes may be written
in Metric units and recognized by the brewer as such. If you are more comfortable with Metric units, but your brewer only
recognizes English units, the Recipe may be entered in Metric, then switched to English before writing the Recipe to the card or
funnel.
The instruction label provides information such as high and low parameter limits, depending on the specific text box you are in.
This label also shows the allowable format for the numerical parameters, such as whether fractional amounts are allowed.
Note: In text boxes that allow fractional values (a decimal point), whole numbers may still be used without error.
Most of the text boxes can be typed directly into. The “Tab”, “Shift-Tab” or “Enter” keys can be used to move the cursor on to the
next text box. In order to set the Pulse Brew and Pre-Infusion times, the associated buttons must be clicked and the “OFF” text
boxes must be double-clicked in order to set the times. These steps are present in order to insure that the user is only able to set
Pulse Brew OR Pre-Infusion. Note: Although it is possible to mix Pulse Brew and Pre-Infusion batches on the same recipe,
Pulse Brew and Pre-Infusion cannot be used on the same batch size.
34446 070804