Filter
Top Products
Page 14
22. Using (-) and (+), set the amount of time the brew
cycle will delay (after the presoak cycle shuts off)
before resuming brewing.
23. When finished, press another batch size and re-
peat until all three batch sizes are set.
24. When finished setting all batch sizes, press DONE.
The display will show the ON and OFF TIMES that
were entered for a particular batch size. After a 5
second delay, the display should read 3 BATCHES
DONE.
25. If the three batches are not complete, press NO in
order to return to SET PREINFUSION, and repeat
steps 19 through 24.
26. If the three batches are correct, press YES. This will
advance to the next function, SET DRIP TIME.
(Refer to page 25 for description of SET DRIP
TIME function.)
27. The display should now read DRIP TIME, along
with either the word OFF, or a time will be showing.
A batch light should also be blinking.
28. Using (-) and (+), set the amount of time from
when the brew spray ends to when the funnel is
emptied of hot liquid for that batch size.
NOTE: Set to OFF to prevent funnel locks from engag-
ing (to disable this function), for a particular batch
size. To set to OFF, continue to press and release (-)
until OFF appears on the screen.
29. When finished, press another batch size and re-
peat step 28 until all three sizes are set.
30. When finished setting all batch sizes press DONE.
The display should read 3 BATCHES DONE?.
31. If the three batch sizes are not correct, press NO to
return to the DRIP TIME setup screen and repeat
steps 28 through 30.
32. If the three batch sizes are correct, press YES. The
screen should show the name of the coffee being
programmed (modified) along with SETUP COM-
PLETE.
32. After a 5 second delay, the display will advance to
the next coffee name in the brewer's memory. If no
other coffee names are present, the display will
read THAT WAS THE LAST RECIPE, and return to
the REVIEW RECIPES screen.
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
29877 080301
SET NEW RECIPES (cont.)
P2418