Filter
Top Products
16
BLK to BLU
from Door
Interconnect
Harness
SERVICE (cont.)
BALLAST
FIG. 4 BALLAST
Location
The front door lamp ballast is located behind
the front access panel on the left side of the compo-
nent bracket.
Test Procedure
1. Disconnect the dispenser from the power source.
2. Disconnect the two black leads on the ballast from
the door interconnect harness and the dispenser
main harness.
3. Check for continuity between the two black leads
on the ballast.
If continuity is present as described the ballast is
operating properly.
If continuity is not present as described, replace the
ballast.
Removal and Replacement
1. Disconnect the wires from the ballast.
2. Remove the two #8-32 screws securing the bal-
last to the component bracket.
3. Remove and discard ballast.
4. Install new ballast using two #8-32 screws to
secure ballast to the component bracket..
5. Refer to Fig. 5 when reconnecting the wires.
BLK to Main Wiring
Harness
P1637.40
FIG. 5 BALLAST TERMINALS
P1447