Filter
Top Products
5
GENERAL INFORMATION
NOTE - THE BREWER IS NOT READY TO PLUG IN
(See Page 6)
Improper installation will result in permanent damage and void the
limited warranty. Read & follow the instructions on the next page.
• This brewer is designed to remain plugged in at all times
(except during initial installation or when cleaning).
• A vacation switch is provided on the lower left side to completely shut
off all electrical components when your plans take you away from home
for three or more days. Safety features, designed into the BUNN
®
coffee
brewer, make the daily use of this switch unnecessary.
• Whenever the brewer has been shut off or unplugged, fi ll the tank with
water and allow the water in the tank to heat to the proper temperature
before using (about fi fteen minutes or until the heating sound stops).
• Your BUNN
®
coffee brewer has a specially designed tank to keep the
water at the proper temperature. This constant supply of hot water assures
the correct method of brewing coffee, in less than three minutes.
• The brewed coffee fl ows into the decanter where it is kept at serving
temperature on the porcelain decanter warmer. The warmer is controlled
by the lighted on/off switch on the front of the brewer.
NOTE-
The warmer switch
only
only
controls the decanter warmer.
• While coffee is being brewed, the newest water in the tank is heated to
the proper temperature and held until needed.
• When the brewer is not in operation, the fl ip lid should remain closed.
Leaving the lid open may cause an unexpected drip of water from the
sprayhead when cold water is poured into the top of the brewer.
• The decanter lid reduces coffee evaporation and temperature loss.
• Use
CAUTION
when dispensing hot water from the brewer. The water
is approximately 50°F hotter than that available from your hot water
faucet and is always available for other uses.
• The brewer is equipped with a 120 volt, three prong grounded cord
set. The plug is provided with a round grounding pin. This is a safety
feature and allows the plug to fi t into a properly grounded outlet. If the
plug does not fi t into the outlet, contact an electrician to update your
outlet. Do not attempt to bypass the safety aspect of this plug.
• The sprayhead may periodically become loose. Using extreme caution
not to burn yourself, retighten the sprayhead with your fi nger tips.
NOTE-
A severe burn may result if the sprayhead becomes
loose and falls off while brewing.