Bunn GR10-B Coffeemaker User Manual


 
7
BREWING DELICIOUS COFFEE
O
F
F
O
N
B
U
N
N
10
8
6
4
w
w
w
.
b
u
n
n
o
m
a
t
i
c
.
c
o
m
O
N
W
A
R
M
E
R
BUNN
O
F
F
Insert a BUNN
®
coffee fi lter into the brew funnel.
(Be sure to use BUNN
®
coffee fi lters for proper brew-
ing. There is a difference.)
Order more paper fi lters direct from BUNN
®
at:
www.bunn.com
Measure coffee into the fi lter and gently shake the
lter to level the bed of grounds. To determine the
amount of coffee to be used, see Page 8.
Make sure that the sprayhead is tight. Slide the brew
funnel into the brewer under the warmer switch. Place
the lighted warmer switch in the “ON” position.
Raise the hinged fl ip-lid and pour a decanter of water
into the top of the brewer. Place the decanter on the
warmer, THEN close the lid. Your BUNN
®
brewer will
begin brewing coffee immediately. Flip-lid should also
remain closed when brewer is not in operation.
P-206
P-205
P2241
P2247
P-215
When brewing has stopped, remove the brew funnel
and discard the fi lter and grounds. Do not touch hot
grounds.
NOTE:
Opening the lid during brew cycle will interrupt the fl ow of water into the tank,
but will not interrupt the brewing process. The brewed coffee already in the funnel
will empty into the decanter. When lid is closed, the fl ow of water into the funnel will
resume until the brewing cycle is complete.
WARNING:
Do not close the lid after pouring in water, without the decanter in place.
Closing the lid releases the hot water.
HOT WATER (USE WITH CAUTION)
The same basic steps can be used to obtain hot water by omitting the fi lter and coffee.
The water from your BUNN
®
coffee brewer is approximately 200° F. This
is hotter
than the hot water from your faucet and must be handled with care.
Step 1
Step 2
Step 3
Step 4
Step 5